DOLPHIN ROD HOLDERS
EXPLODED VIEW OF THE DOLPHIN TWIN ROD HOLDERS
STEP 1:
Unpack and check the contents of the box and check parts list.
Please Read all Instrustions prior to installation
If you are NOT sure of any part of the guide or you have any questions
Please contact the supplier or DOLPHIN T Tops
PARTS LIST
STEP 2: BALL CLAMP ASSEMBLY.
(A) Use two of the M6 bolts and attach the 2 x C sections of the clamp together. If needed insert
the rubber colloar around the inside of the ball clamp.
NOTE: The raised lip of the rubber collar will !t nicely around at the edge of the clamp.
NOTE: The edges of the joint should be "ush, if not turn one of the c section around.
STEP 3: ATTACHING THE BALL CLAMP TO THE TWIN ROD HOLDERS
(A) Attach the ball clamp to the twin rod holder by inserting the two locator lugs into holdes on the
rod holder bracket. On the other side of the twin holders
you insert the bolt through the hole and thread into the clamp and tigthen.
NOTE: The clamp has two location lugs with a threaded center hole. The twin holder has a hole to insert
the bolt into the clamp. You can adjust what angle you require later.
STEP4: ATTACHING TWIN ROD HOLDERS TO T TOP.
NOTE: The clamp size is 2inch you will use the rubber collar to attch to the Dolphin T Top.
The outer lip of the rubber collar will !t nice around the shape of the ball clamp.
NOTE: On the Dolphin T Top there are 4 areas at the back of the top frame for locating your twin
rod holders - so you can have 8 x !shing rods across the back and if need there are position at the front.
Attaching the twin rod holders is simple and quick.
(A) Place the rubber collar around the t top top frame. Put the half C section of the clamp on top of the
rubber collar. Then use the two bolts and attach to the other half of the clamp holding the rod holder.
You can rotate the clamp around the tube to angle the rod holders to the position you want. If you need
to angle the outer position rods away from the boat you can by adjusting the lugs in the clamp.
INSTALLATION GUIDE
Dolphin Twin Rod Holders.
WARNING:
Remove your rods when towing the boat behind your vehicle.
Ensure your rods will not bounce out of your holders whilst using your boat.
Check that your rod holders are !rm and tight before using your boat.
Care and maintain your racks. Clean with soapy water and rinse o" and dry.
Use a marine clear protection spray on bolts for best maintance.
WARRANTY
Indy warrants the product (not including other 3rd party accessories) against manufactures defects.
To claim you must contact Dolphin or its Distributor. The product/part is to be sent to the Distributor
for inspection where it will either be repaired or replaced. (unless otherwise agreed in writing)
The customer is liable for costs associated in shipping the product/part to Dolphin T Tops.
Dolphin is not responsible for personal injury or damage to the boat caused by the use rod holders
or any transport charges or cost of installation or removal of the rod holders.
Dolphin is not liablity for direct or indirect or consequential damages resulting from delay or improper
installation.
Warranty does NOT cover anodised, polished,powder coated surfaces as well as any hardware
corrosion, rubber collars or bungee cords. They are speci!cally excluded as their care and use can not
be controlled by Dolphin T Tops
No dealer, retailer or manufacturer is the agent of James G Pty Ltd and may not assume any liablity in
connection with this warranty. This warranty is in lieu of all.
